Solution 5: Uninstall and reinstall the HP Photosmart Software

Solution 6: Contact HP support for service

Solution 1: Reset the product

Solution: Turn off the product and reset it by disconnecting the power cord. Wait 60 seconds, and then plug in the power cord. Turn on the product.

Cause: You needed to reset the product.

If this did not solve the issue, try the next solution.

Solution 2: Check the power cord and USB cable

Solution: Make sure that the power cord and USB cable are properly attached and plugged in. Also, make sure that the product is turned on.If the product is connected to the computer through a wired, wireless, or Bluetooth connection, make sure that the respective connections are active and the product is turned on.

To check the power supply

1.Make sure the power cord is firmly connected to both the product and the power adaptor. Plug the power cord into a power outlet, surge protector, or power strip.

1Power connection

2Power cord and adaptor

3Power outlet

Troubleshooting

2.Make sure the product is turned on.

3.If the product is not receiving electrical power, connect it to another power outlet.

4.Turn off the product and reset it by disconnecting the power cord.

5.Wait 5 seconds, and plug in the power cord.

6.Turn on the product.

7.Try to scan again.

Errors 239

Page 242
Image 242
HP C6380, C6340 manual Solution 1 Reset the product