Chapter 4

Finish setup

d. Press the down arrow button until Ad Hoc is highlighted, and then press OK.

e. Press the down arrow button until Yes, my network uses WEP encryption is highlighted, and then press OK. The visual keyboard displays.

If you do not want to use WEP encryption, press the down arrow button until No, my network does not use encryption is highlighted, and then press OK. Go to step 7.

6.If prompted, enter your WEP key as follows. Otherwise go to step 7.

a. Use the arrow buttons to highlight a letter or number on the visual keyboard, and then press OK to select it.

NOTE: You must enter the exact uppercase (capital) and lowercase (small) letters. Otherwise, the wireless connection will fail.

b. When you are finished entering the WEP key, use the arrow buttons to highlight Done on the visual keyboard.

7.Press OK again to confirm.

The product will attempt to connect to the SSID. If a message says you entered an invalid WEP key, check the key you wrote down for your new network, follow the prompts to correct the WEP key, and then try again.

8.When the product connects successfully to the network, go to your computer to install the software.

NOTE: You can print the Wireless Network Test report at the end of a successful Wireless Setup Wizard connection which can help identify any potential future issues with the network setup.

Related topics

Install the software for a network connection” on page 34

Network troubleshooting” on page 149

Install the software for a network connection

Use this section to install the HP Photosmart software on a computer connected to a network. Before you install the software, make sure you have connected the HP All-in- One to a network.

NOTE: If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, the HP Photosmart software installer might try to use one of the reserved drive letters and you will not be able to access that network drive on your computer.

NOTE: Installation time can range from 20 to 45 minutes depending on your operating system, the amount of available space, and the processor speed of your computer.

34 Finish setting up the HP All-in-One

Page 37
Image 37
HP C6340, C6380 manual Install the software for a network connection