HP LN17 manual Simm, Kug-appc Page 10 Thursday, March 6, 1997 451 PM

kug-appc Page 10 Thursday, March 6, 1997 4:51 PM

I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s

PostScript

SIMM

Installing the PostScript SIMM

This section contains two sets of instructions:

•“Installing the PostScript SIMM” (below)

•“Removing the PostScript SIMM” (page C-13)

SIMMs and controller boards are sensitive to static electricity. Before installing a SIMM, discharge static electricity from

your body by touching something metal, such as the metal

Caution back plate on any device plugged into a grounded power source. If you walk around before finishing the installation,

again discharge any static electricity.

Never remove the printer controller board while the printer is plugged in.

1 Power OFF the printer and disconnect the power cord and any interface cables.

2 Loosen the thumb screws and pull out the	3 Place the controller board on a ream of
controller board.	paper.

C-10❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e