HP LN17 manual Removing Duplex Module, Kug-appc Page 23 Thursday, March 6, 1997 451 PM

kug-appc Page 23 Thursday, March 6, 1997 4:51 PM

D u p l e x M o d u l e

Removing the

Duplex Module

1 Power OFF the printer and disconnect the power cord and any interface cables.

2 Open the rear cover.	3 Remove the Duplex Module by pushing
	the green lock buttons on either side of it.

Be careful not to touch the metal part of the motor at the right end of the duplex module—it is hot after continuous two-sided printing.

Store the Duplex Module in its original packaging.

4 Close the rear cover, plug in the power cord, and power ON the printer.

After warming up for a few minutes, the Control Panel displays the following message:

Online

Ready

If any other message is displayed, see

Table 6.2 starting on page 6-6.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-23