kug-appc Page 16 Thursday, March 6, 1997 4:51 PM

I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s

Hard Drive This section contains two sets of instructions:
•“Installing the Hard Drive” (below)
•“Removing the Hard Drive” (page C-19)

The hard drive and controller board are sensitive to static electricity. Before installing the hard drive, discharge static

electricity from your body by touching something metal, such

Caution as the metal back plate on any device plugged into a grounded power source. If you walk around before finishing

the installation, again discharge any static electricity.

Never remove the printer controller board while the printer is plugged in.

Installing the

Hard Drive

1 Power OFF the printer and disconnect the power cord and any interface cables.

2 Loosen the thumb screws and pull out the

3 Place the controller board on a ream of

controller board.

paper.

C-16❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e