kug-appc Page 49 Thursday, March 6, 1997 4:51 PM

I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s

Installing the DNIC

Be sure to read Chapter 2 of the DNIC-E’NET Configuration

Guide for important network connection instructions.

Note

1 Power OFF the printer and disconnect the power cord and any interface cables.

•If installing the DNIC-E’NET, continue with Step 2.

•If installing the DNIC-L’TALK, skip to Step 3.

2 Note the DNIC-E’NET serial number (A)

3 Loosen the thumb screws and pull out the

and Ethernet address (B).

controller board.

This information will not be accessible after the card is installed.

Pins 2 and 3 on JX1 (C) must be strapped together for proper operation of the DNIC-E’NET.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-49