HP LN17 kug-ch06Page 8 Thursday, March 6, 1997 4:48 PM, Disk, Disk Failure, Disk Format Bad, Disk Not In Use, Disk Read Error, Disk Write Error

kug-ch06 Page 8 Thursday, March 6, 1997 4:48 PM

C o n t r o l P a n e l M e s s a g e s

Table 6.2 Control Panel messages (continued)

Message			Description/Corrective Action
Disk	A hard disk error has occurred.
	ACTION:	Power cycle the printer. If this message reappears, power off the
		printer and contact your dealer or Digital.
Disk Failure	A general failure of the hard disk has occurred.
	Under this message, the following message is displayed:
	Press *
	ACTION:	Press Enter	. The printer displays the following message:
		Disk Not In Use
		Printing resumes without use of the hard disk.
Disk Format Bad	The hard disk high level format (FAT tables) cannot be understood. This is NOT
	because a new disk has been installed.
	ACTION:	Either initialize the disk format procedure by pressing Up			, or abort
		the procedure by pressing Down		.

This message flashes alternately with the two-line message:

Press − to init

Press ↓ to Abort

Disk Not In Use	A failure of the hard disk has occurred and been acknowledged. Printing resumes
	without use of the hard disk.
	ACTION:	Make sure the hard disk is properly seated on the controller board. If
		the problem remains, contact your dealer or Digital.
Disk Read Error	The printer cannot read data from the hard disk.
	ACTION:	Try powering the printer OFF then ON again. Make sure the hard disk
		is properly seated on the controller board. If the problem remains,
		contact your dealer or Digital.
Disk Write Error	The printer cannot write data to the hard disk.
	ACTION:	Press Enter	. The printer will mark the disk sector as bad and retry
		the write operation at another location on the disk. Make sure the
		hard disk is properly seated on the controller board. If the problem
		remains, contact your dealer or Digital.
			Table 6.2 Page 3 of 19

6-8❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e