HP LN17 manual Kug-ch06 Page 6 Thursday, March 6, 1997 448 PM, Message

kug-ch06 Page 6 Thursday, March 6, 1997 4:48 PM

T r o u b l e s h o o t i n g

Control Panel Messages

Listed in Table 6.2 are Control Panel messages that either:

•Cause the printer to stop printing.

•Require the user to call for service.

Also included in Table 6.2 are common, non-error messages you are likely to see. The messages are listed in alphabetical order, preceded by numerical diagnostic error codes.

Table 6.2 Control Panel messages

Message			Description/Corrective Action
0001†		A fault condition has occurred.
†	Appears in the upper left	ACTION:	Reseat the controller board and test the printer again. If the problem
	corner of the display.		continues, reseat the ROM SIMM(s) on the controller board and test
			the printer again. If the problem still continues, observe the diagnostic
			LED at power on. If the LED does not glow, or glows continuously,
			contact your dealer or Digital. If the LED flashes, refer to Table 6.3 on
			page 6-25 for further information.
0040†		A fault condition has occurred.
†	Appears in the upper left	ACTION:	Reseat the controller board and test the printer again. If the problem
	corner of the display.		continues, observe the diagnostic LED at power on. If the LED does
			not glow, or glows continuously, contact your dealer or Digital. If the
			LED flashes, refer to Table 6.3 on page 6-25 for further information.
0100†		A fault condition has occurred.
†	Appears in the upper left	ACTION:	If there is a memory SIMM in slot SIM3, remove it. Move the memory
	corner of the display.		SIMM in slot SIM2 into SIM3, then test the printer again. If code 0101
			is displayed at power on, replace the SIMM. If code 0101 is not
			displayed at power on, move the SIMM back to SIM2 and test the
			printer again. If code 0100 again displays at power on, contact your
			dealer or Digital.
0101†		A fault condition has occurred.
†	Appears in the upper left	ACTION:	If there is a memory SIMM in slot SIM2, remove it. Move the memory
	corner of the display.		SIMM in slot SIM3 into SIM2, then test the printer again. If code 0100
			is displayed at power on, replace the SIMM. If code 0100 is not
			displayed at power on, move the SIMM back to SIM3 and test the
			printer again. If code 0101 again displays at power on, contact your
			dealer or Digital.
			Table 6.2 Page 1 of 19

6-6❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e