HP LN17 manual Kug-appc Page 17 Thursday, March 6, 1997 451 PM

kug-appc Page 17 Thursday, March 6, 1997 4:51 PM

4 Align the hard drive connector to the

controller connector (J180), and gently lay the hard drive on top of the four standoffs.

H a r d D r i v e

5 Push down on the drive until all four corners latch into place.

6

7

Replace the controller board, sliding it along the alignment channels. Then hand-tighten the thumb screws.

Replace the power and interface cables and power ON the printer.

If the drive is already formatted, the Control Panel will display:

Online

Ready

If the drive is unformatted, the Control Panel will display:

Press − to Init

Press ↓ to Abort

If any other message is displayed, see Table 6.2 starting on page 6-6.

If you need to format the drive, continue to Step 8 on page C-18. Otherwise, skip to Step 9 on page C-18.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-17