kug-appc Page 9 Thursday, March 6, 1997 4:51 PM

M e m o r y S I M M s

4 Carefully push out on the locking clips to release the SIMM.

5

6

7

Rotate the SIMM down out of position, then lift it out.

Replace the controller board, sliding it along the alignment channels. Then hand-tighten the thumb screws.

Replace the power and interface cables and power ON the printer.

After warming up for a few minutes, the Control Panel displays the following message:

Online

Ready

If any other message is displayed, see Table 6.2 starting on page 6-6.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-9