Installing the Battery
Your camera can use either a rechargeable HP Photosmart R07 lithium ion battery (L1812A) or a disposable Duracell® CP1 battery.
NOTE If a rechargeable battery was shipped with your camera, it will be partially charged, but you should fully charge it before using it the first time. You can charge the battery while it is in the camera. See Charging the Battery on page 16.
1If the Battery/Memory card door is already open, skip this step and go on to step 2.
Hold the camera with the bottom facing up, and the front of the camera facing you. Then slide the Battery/Memory card door on the bottom of the camera away from you, toward the back of the camera.
2Insert the battery in the larger slot as shown, and push it in until the latch catches.
3Close the Battery/Memory card door by pushing the door down and then sliding the door toward the front of the camera until the door latches.
To remove the battery from the camera, first turn the camera off. Then open the Battery/Memory card door, release the battery latch, tilt the camera, and the battery will slide out of its slot.
14 | HP Photosmart R707 User’s Manual |