HP R707 manual Resetting the Camera

Resetting the Camera

If your camera does not respond when you press any buttons, try resetting the camera as follows:

1Holding the camera upside down with the back of the camera facing you, open the battery/memory card door on the bottom of the camera.

2Remove the battery from the camera, and make sure the HP AC power adapter is not connected to the camera.

3The Reset switch is the small hole located above the battery slot, as shown. Press the straightened end of a paper clip into the Reset switch until the switch is depressed, and hold it down for approximately three seconds, then remove the paper clip. The camera is now reset.

4Reinsert the battery and close the battery/memory card door. You may now use the camera again.

124 HP Photosmart R707 User’s Manual