HP UX SNAplus2 manual Remote Command Facility, Configuration Files

Introduction to SNAplus2

SNAplus2 Administration

•snapadmin -h-dcommandprovides detailed help for the named command, including a list of the configuration parameters that can be specified with the command.

Refer to the HP-UX SNAplus2 Administration Command Reference for more information.

Remote Command Facility

The remote command facility (RCF) provides the following facilities to support the administration of SNAplus2 from a NetView console on a host:

•Service point command facility (SPCF) enables an operator at a host NetView console to manage SNAplus2 from NetView by issuing SNAplus2 administration commands.

•UNIX command facility (UCF) enables the NetView operator to issue standard HP-UX commands on the SNAplus2 computer.

For more information about RCF, see Chapter 10, “Managing SNAplus2 from NetView.”

Configuration Files

Configuration information for the SNAplus2 system is held in the following text files:

Node configuration file

The sna_node.cfg file contains information about SNAplus2 node resources for a specific node. This file resides on the computer where the node runs. This file includes information about the node's resources and specifies which resources are active when SNAplus2 is started on the node. This file provides an initial definition of the resources that are available; you can then use the other administration tools to modify the running node's resources as your requirements change. Any modifications you make are automatically saved to the file, so that the modified configuration can be used again when the node is stopped and restarted.

Domain configuration file

102 Chapter 2