IBM 1120, 1125 manual Power Saver, Print Timeout, 167, 225

Power Saver

Purpose:

To specify the amount of time (in minutes) the printer waits after a job is printed before it goes into a reduced power state.

Values:

1...240 (60*) Specifies the amount of time after a print job before the printer goes into Power Saver mode.

Power Saver replaces the Ready message. When the printer is in Power Saver mode, it is still ready to receive print jobs.

Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an electrical circuit with room lighting and you notice lights flickering.

Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a balance between energy consumption and a shorter warm-up period.

Print Timeout

Purpose:

To specify the amount of time (in seconds) the printer waits before printing the last page of a print job that does not end with a command to print the page. The print timeout counter does not start until Waiting is displayed.

Values:

Disabled	The printer does not print the last page of a print job until one of the following occurs:
	• The printer receives enough information to fill the page.
	•	The printer receives a Form Feed command.
	•	You select Print Buffer from the Job Menu.
1...225 (90*)	The printer prints the last page after the specified time.

See also:

Print Buffer

167

Argecy Computer Corporation 248-324-1800