Figure 43. Removing the front cover

Installing the front cover and front door on a stand-alone 8202-E4B or 8205-E6B system

Use this procedure to install the cover to access components or perform service.

To install the front cover and front door, complete the following steps.

1.Align the cover (A) until the two cover tabs are seated into the slots on the base plate (B), as shown in the following figure.

2.Rotate the cover up and towards the system until the release latch is seated into its respective slot. The cover has an indentation where you can hold onto it more easily.

52Power Systems: Power supplies for the 9117-MMB or 9179-MHB

Page 64
Image 64
IBM 9179-MHB, 9117-MMB manual Removing the front cover