IBM 9179-MHB, 9117-MMB manual Connecting the power cords to the 8202-E4B or 8205-E6B system

Connecting the power cords to the 8202-E4B or 8205-E6B system

Use this procedure to connect the power cords.

1.Identify the system unit you are servicing in the rack.

2.Connect all power cords to the unit you are servicing. Ensure that the cords are threaded through the handles.

Figure 54. Connecting the power cords

3.Close the back rack door.

Installing a feature by using the Hardware Management Console

You can use the Hardware Management Console to perform many service actions, including the installation of a new feature or part.

To use the Hardware Management Console user interface to install a feature or part into a system or expansion unit that is managed by an HMC, follow these steps:

1.In the navigation area, expand Systems Management → Servers.

2.Select the managed system you will install the part in.

3.In the Tasks area expand Serviceability → Hardware → MES Tasks.

4.Select Add FRU (field replaceable unit).

5.In the Add/Install/Remove Hardware window select the system or enclosure into which you are installing the feature.

6.Select the type of feature you are installing from the menu and click Next

7.Select the location code for where you will install the feature, and click Add.

8.After the FRU is placed in the pending actions category click Launch Procedure and follow the instructions to install the feature.

60Power Systems: Power supplies for the 9117-MMB or 9179-MHB