64IBM Sterling Connect:Direct for i5/OS User’s Guide
current specifies the status of the file before the operation executes. Valid values for this subparameter are:
NEW specifies that the operation creates the destination file or member. If you are creating a member, the file can already exist but the member must not already exist. If you are creating a file (SAVF), the file must not already exist.
OLD specifies that the destination file or member already exists. The operation has exclusive control of the member. If the file or member does not exist, the receive operation fails.
MOD specifies that the operation modifies the file or member by adding data to the end of the member or, if none exists, allocates a new member. The file is also created if it does not exist.
RPL indicates that the destination file or member is replaced. The file is created if it does not exist.
SHR indicates that another operation can read the file simultaneously. The file or member is created if it does not exist on i5/OS.
Note: Currently, normal end disposition and abnormal end disposition are not applicable when sending to Sterling Connect:Direct for i5/OS.
TRACEOPT
Trace Instructions
(L, S, F, C, X, K, D, H, V, W, P,*NONE*ALL*EXT *COMMON*INITPARMS*CURRENT
specifies the trace bits that define functions to be traced by Sterling Connect:Direct for i5/OS. The following are valid options:
L enables the main line logic trace for all components.
S enables the Process step logic trace.
F enables the file handler trace.
C enables the communications logic trace.
X enables the XDR trace.
K enables the KQV logic trace.
D enables the
H enables the FMH dump.
V enables the XDR dump.
W enables the communications dump.
P enables the CIPC dump.
*NONE turns off all traces.
*ALL enables all product traces.(L, S, F, C, X, K, D, H, V, W and P)
*EXT enables all product traces plus two system traces (TRCICF and TRCJOB).
*COMMON enables the communications traces. (L, S, F, C, and H)
*INITPARMS indicates the traces specified in the initialization parameters.
*CURRENT selects the trace bits that the session manager is currently using.
Command Trace Options
L,S,F,C,X,K,D,H,V,P*ALL*EXT*COMMON *NONE)
specifies the trace bits that define functions to be traced for this command but not for the Process it runs. The following are valid options:
L enables the main line logic trace for all components.
S enables the Process step logic trace.
