Action

Make sure that you are running only supported commands.

CMMCI9010E The command did not complete successfully.

Explanation

The command did not complete successfully.

Action

Verify that you are using the correct syntax. Then run the command again.

CMMCI9013E Command: command_name was not found.

Explanation

You attempted to run a command that does not exist.

Action

Make sure that you run valid administrative command-line interface commands.

Enter helpfor a list of available commands.

CMMCI9014E The parameter -parameter_nameis not valid.

Explanation

You attempted to run a command, but the parameter that you specified is not valid.

Action

Run the command again, specifying valid parameters. Enter help command_namefor a list of valid parameters.

CMMCI9015E The value value for parameter -parameter_nameis not formatted correctly.

Explanation

The parameter that you specified is not formatted correctly.

Action

Run the command again, specifying parameter values that are formatted correctly. Enter help command_namefor a list of valid parameters.

CMMCI9016E Missing parameter name after -.

Explanation

You specified a dash, but you did not specify a parameter name after the dash.

Chapter 1. Framework messages 3

Page 23
Image 23
IBM DS8000 manual CMMCI9010E The command did not complete successfully, CMMCI9013E Command commandname was not found