IBM DS8000 manual CMUC00131E Commandinfo Operation failure

Action

Specify source volumes that are all contained within the same logical subsystem, and then resubmit the command. Issue separate commands for volumes that are contained within different logical subsystems.

CMUC00130E COMMAND_INFO All target volumes must be within the same logical subsystem.

Explanation

The -tgtssflag is specified with the command. This flag requires that all target volumes are contained within the same logical subsystem. Not all of the target volumes specified are contained within the same logical subsystem.

Action

Specify target volumes that are all contained within the same logical subsystem, and then resubmit the command. Issue separate commands for volumes that are contained within different logical subsystems.

CMUC00131E COMMAND_INFO Operation failure

Explanation

The lshostvol command fails for one of the following reasons:

vThe CLI installation did not complete successfully.

vA platform-dependent external command is being invoked unsuccessfully.

vYou lack sufficient privileges.

Action

Check the CLI installation log for errors and reinstall if necessary. Ensure that you have the appropriate privileges to perform the task. If the problem persists, contact IBM technical support for assistance.

CMUC00132E COMMAND_INFO Command interrupted. Resubmit the command.

Explanation

The lshostvol command was interrupted for an unknown reason.

Action

Resubmit the command. If the problem persists, contact IBM technical support for assistance.

CMUC00133I COMMAND_INFO User USERNAME successfully created.

Explanation

The user has been created successfully.

Chapter 2. DS command-line interface messages 43