IBM MaxLoader manual To install the Software for parallel port programmers

MaxLoader User’s Guide

NOTE: Watch the model name in left-up corner screen and the ProMax- 4G(8G) won’t be ready if “DEMO mode” appears in the screen. Check the USB cable and turn on the AC switch in the back side of unit.

To install the Software for parallel port programmers

There are three different addresses for the parallel port. When you select an address from LPT1, LPT2, LPT3, one of them should be valid without a communication error message. Turn the AC switch ON before running the MaxLoader software. Make sure you connect the printer (IEEE) cable between TopMax/ChipMax and your available printer port and lock the shields in each side of the cable. Be sure that your programmer recognizes your computer’s parallel port address when you execute the MaxLoader icon. (MEMO mode is indicated that your programmer has a “communication error”)

1.Connect print cable between PC and programmer.

2.Connect AC cord to programmer.

3.Turn on AC switch located on the back side of TopMax

4.Install programmer software that comes in a CD-R (or download the latest software (all-in-one) from www.eetools.com

5.After the MaxLoader is installed, you choose a programmer name in the very first screen menu

To download the software from the www.eetools.com web site

1.Click on “Software download” button on left at www.eetools.com and download MaxLoader software. The file will be saved to your hard disk. The MaxLoader can be operated for All-in-one (all programmers-in-one software).

2.Once the download is complete, double-click on the file name to install the software.

17