Integra DTR-10.5 instruction manual Index Parts and Facilities

Index Parts and Facilities—Continued

For further operational instructions, see the pages indicated in brackets [ ].

1Standby indicator [9, 52]

Lights when the DTR-10.5 is in the standby state and when a signal is received from the remote controller.

2Standby/On button [52]

Press this button, the DTR-10.5 turns on and the display lights up. If pressed again, the DTR-10.5 returns to the standby state. In the standby state, the display is turned off and the DTR-10.5 cannot be operated.

3Remote control sensor [9]

4Display button [56]

Press to display information about the current input source signal. Each time you press the [Display] button, the screen changes to show you different information concerning the input signal.

5Front display

6Input source buttons and indicators (DVD, Video 1-7, Tape 1-2, Tuner, Phono, CD, and Net Audio) [52]

Press these buttons to select the input source for the main zone.

After selecting the input source, the corresponding indicator turns blue. If you select Zone 2, the indicator turns green. If you select Zone 3 or Rec, the indicator turns red.

7Master Volume dial [52]

Use to control the volume in the main zone. The volume for the remote zone (Zone 2 and Zone 3) is independent.

8Open button

Press this button to open the front panel door.

9Pure Audio indicator

Lights during pure audio playback.

Inner panel

0Listening Mode button [61]

Press this button to enter the setup mode for the listening mode. Turning the [Select/Preset] allows you to select the listening mode. To confirm your selection and exit the setup mode, press the [Select/ Preset].

AAudio Selector button [57]

Press this button to enter the audio selector mode. Turning the [Select/Preset] allows you to select the audio mode.

BTone button [54]

Press this button to enter the tone adjustment mode. Turning the [Select/Preset] allows you to select the channel to adjust the tone. To adjust the tone level, turn the [Control/Tuning].

CZone 2 button [68]

Press this button to enter the Zone 2 configuration mode. Turning the [Select/Preset] allows you to select the input source for Zone 2. Also, if you want to configure other Zone 2 settings such as standby/ on setting, listening mode, volume adjustment, audio selector mode, and display settings, press this button first.

DRec/Zone 3 button [68, 70]

Press this button to enter the Rec/Zone 3 mode. Turning the [Control/Tuning] allows you to select the input source for the Rec mode or Zone 3. Also, if you want to configure the setting for Zone 3 including standby/on setting or volume adjustment, press this button first.

Note:

Recording and Zone 3 operations uses the same circuit and therefore cannot be used at the same time.

EVideo 7 Input terminals [40]

For connecting a video camera or game device.

FZone 3 Level button [68]

Getting Started

Press this button to enter the volume adjustment mode for Zone 3. Turning the [Select/Preset] allows you to adjust the volume.

GControl/Tuning dial

When the input source is FM or AM, turning this jog dial allows you to select the frequency to receive. When used with other buttons, this [Control/ Tuning] dial is used to select the mode settings or values. Also the dial is pressed to confirm the settings or values you select.

HSetup button [86]

Press this button to enter the setup mode. First, select the parameter to change by turning the [Select/Preset] and press the [Select/Preset] to confirm the parameter. Then, change the parameter value by turning the [Control/Tuning] and press the [Control/Tuning] to confirm the value.

13