Integra DTR-10.5 141, Resetting the Remote Controller, RESET, and then press the scroll

Other Settings for the Remote Controller—Continued

Resetting the Remote Controller

You can reset the remote controller to its default set- tings.

1	Press and hold the [Custom] but-
Custom	ton for more than three seconds.
	The remote controller enters Custom
	mode.
2	Roll the scroll wheel to select
	“SETUP,” and then press the scroll
	wheel.

3	Roll the scroll wheel to select
	“RESET,” and then press the scroll
	wheel.

4	Roll the scroll wheel to select
	“YES,” and then press the scroll
	wheel.
	The remote controller is reset to its
	default settings.

Using the Remote Controller with Radio Frequency

You can set the remote controller’s transmission signal format to either infrared (IR) or radio frequency (RF). The default setting is IR.

This is useful when, for example, the DTR-10.5 is installed in a rack or is not in line of sight of the remote controller as it allows you to use a commercially avail- able RF receiver to pick up commands from the remote controller, which are then fed to the DTR-10.5 via its IR IN socket. For this to work, you must assign the same ID and channel to the remote controller and RF receiver.

1	Press and hold the [Custom] but-
	ton for more than three seconds.
	Custom
	The remote controller enters Custom
	mode.

2

3

4

5

6

Roll the scroll wheel to select

“SETUP,” and then press the scroll wheel.

Roll the scroll wheel to select “IR/ RF,” and then press the scroll wheel.

Roll the scroll wheel to select “IR” or “RF,” and then press the scroll wheel.

When you select “IR.”

If you select “RF,” roll the scroll wheel to select the same ID as the RF receiver, and then press the scroll wheel.

IDs 0 to 9 and A to F can be selected.

Roll the scroll wheel to select the same channel as the RF receiver, and then press the scroll wheel.

Channels 0 to 3 can be selected.

If the ID and channel have been set suc- cessfully, “OK” appears on the display.

Using the Remote Controller

141