Integra DTR-10.5 Recording a Source, Enjoying Movies and Music in the, Remote Zone Zone 2/3

Enjoying Movies and Music in the

Remote Zone (Zone 2/3)—

Continued

•When not using Zone 2 or Zone 3, press the [Zone 2] (or [Rec/Zone 3]) button, and then press the [Standby/On] button. Or press the [Zone 2] (or [Rec/Zone 3]) button, and then turn the [Select/Preset] dial to select “Off.” In the case of Zone 2, the green indicator on the input source button is turned off, and in the case of Zone 3, the red indicator is turned off.

•When operating in the main room, be sure to confirm that the [Standby] indicator is not blinking, and then start operations. When not using in the main room, press the [Standby/ On] button. If the DTR-10.5 is in the standby status, the power supply to Zone 2 and Zone 3 is not switched off.

Recording a Source

The DTR-10.5 can not only record the playing source but can also record a source while playing another source. You can also combine a video and audio to cre- ate a new source.

Signals that can be output to a video/audio recording device vary with the type of jack connected. Check the following conditions before starting recording:

Audio

•Signals (analog) from the ETHERNET, PH, or AUDIO IN jacks are output only to the AUDIO OUT jacks. Music signals of MP3, WMA, and WAVE to be played with Net-Audio are also output only to analog audio output jacks.

•No signal is output from the MULTI-CH IN jacks.

•No signal is output from the HDMI IN jacks. Record- ing via the HDMI OUT jack is also disabled because Rec Out is not available in Audio Output Assign.

•Signals from the DIGITAL IN OPTICAL or COAX- IAL jacks are output to the DIGITAL OUT OPTI- CAL or COAXIAL jacks. PCM signals are converted into analog signals, and also output to the AUDIO OUT jacks.

•Only PCM signals are output from the i.LINK (AUDIO) terminals to the AUDIO OUT jacks. Digital signals are output from the i.LINK (AUDIO) termi- nals to the DIGITAL OUT OPTICAL or COAXIAL jacks, but signals on Super Audio CD and DVD- Audio are not output.

Video

•Video signals from the VIDEO IN, S VIDEO IN, or COMPONENT VIDEO IN jack are output only to the VIDEO OUT jacks.

Operations

69