Integra DTR-10.5 instruction manual Configuring the Music Server

Enjoying Net Audio—Continued

Configuring the Music Server

The music server settings can be made while you select the music server as an input source.

			On	Standby	TV
					I	Input
			1	2	3	+
			@.-'/	ABC	DEF	TV CH
			4	5	6	-
			GHI	JKL	MNO
			7	8	9
			PQRS	TUV	WXYZ	TV VOL
			+10	0	Clear
			--/---		#
					Direct Tuning
			Custom
						Zone 3
			Macro			Zone 2	Scroll wheel
			Mode			Input	Input
			Dimmer			Sleep
			TV	enu	M
Enter,				M	en
			Input	op	u
				T	dioA
				Ser
			+	ver	Au
/	/	/			J
					D
			CH	Enter		VOL
			Disc
			-	E	ide		Setup
			Prev
				Re	up
				xit	Gu
			CH	turn	Set
			Display			Muting

1	Press the [Input] button, and
	Input

then roll the scroll wheel to select MSRV.

Make sure that the “MSRV” is displayed when you configure the music server.

2		Press the scroll wheel, and then
		press the [Setup] button to display
		the Main Menu.
		p
	tu
	Se
3		Use the [ ]/[ ] buttons to select
		“Input Setup,” then press the

[Enter] button.

4

Enter

Enter

5

Enter

6

	p
tu
Se

Use the []/[ ] buttons to select the “Music Server” sub-menu, then press the [Enter] button.

The setup screen for the sub-menu appears.

Use the [] and [ ] cursor but- tons to select “Select Server” and then use the [] and [ ] cursor buttons to select the desired server.

Select a network server that exists on the network.

*mark appears next to the servers detected on the network. If there is a server that does not have a * mark, make sure that the server is running.

“Not Found” message indicates that no server is currently available for selec- tion. If the message appears, make sure that the server is connected and running.

Press the [Setup] button.

This completes the configuration proce- dure and the menu disappears.

Tips:

When choosing settings on the DTR-10.5, after selecting the input source using the input source buttons, press the [Setup] button. Next, select the menu you want to configure by turning the [Select/Preset] dial and press the dial to confirm the selection. Then, after selecting the sub- menu you want to configure by turning the [Select/Preset] dial, select your value by turning the [Control/Tuning] dial, and press the dial to confirm the value. If you want to go back to the previous operation,

Enter

Enter

press the [Exit] button.

80