Integra DTR-10.5 instruction manual OSD Map Zone, 106

Setup Menu—Continued

OSD Map (ZONE 2)

The Zone 2 settings shown on this		Reference
page can be made when you		pages
	0.Hardware Setup
perform either of the following
	=====================
settings in the “MAIN A” setup	1.TV Format Setup		87
menu.

•Under the “Speaker/Output Setup → Speaker Configuration” menu, when you select the surround back setting to “Powered Zone 2.” (The main menu 1 below)

• Under the “Speaker/Output		1.Speaker Setup
	Setup → Audio (Video) Output	=====================									89
	Assign” menu, when you select	1.Speaker Impedance
	the output terminal setting to
	“Zone 2 Out.” (The main menu 2
	below)
	(Main menu 1)
		2.Input Setup
	Zone 2 Setup		96
		==Input:XXXXXXXXX====
	=====================
	0.Hardware Setup	1.Listening Mode Preset
	1.Speaker Setup	2.Delay						98
	2.Input Setup
	3.Listening Mode Setup
	4.Audio Adjust
	5.Preference								99
	(Main menu 2)
		3.Listening Mode Setup			100
	Zone 2 Setup	=====================
	=====================	1.Mono Setup
	0.Hardware Setup	2.Multiplex Setup
		3.Stereo Setup
							106
	2.Input Setup	4.Dolby Digital Setup
	3.Listening Mode Setup	5.DTS Setup
	4.Audio Adjust	6.AAC Setup				108
		7.Dolby Virtual
	5.Preference
		Speaker Setup
				109
										116
		4.Audio Adjust
		=====================
		1.Tone Control						118

5.Preference

=====================

1.Volume Setup

2.OSD Setup 119

3.OSD Position

Setup Menu

85