Intel 41210 manual Board Layout Guidelines, Adapter Card Topology

Board Layout Guidelines 7

This chapter provides details on adapter card stackup suggestions. It is highly recommended that signal integrity simulations be run to verify each 41210 Bridge PCB layout especially if it deviates from the recommendations listed in these design guidelines.

7.1Adapter Card Topology

The 41210 Bridge will be implemented on PCI-E adapter cards with an eight layer stackup PCB. The specified impedance range for all adapter card implementations will be 60Ω +/-15%. Adjustments will be made for interfaces specified at other impedances. Table 3 defines the typical layer geometries for eight layer boards.

Table 3.	Adapter Card Stack Up, Microstrip and Stripline
	Variable	Type	Nominal	Minimum	Maximum	Notes
			(mils)	(mils)	(mils)
Solder Mask Thickness (mil)		N/A	0.8	0.6	1.0
	Solder Mask Er	N/A	3.65	3.65	3.65
Core Thickness (mil)		N/A	2.8	3.0	3.2
	Core Er	N/A	4.3	3.75	4.85	2113 material
Plane Thickness (mil)		Power	2.7	2.5	2.9
		Ground	1.35	1.15	1.55
		1	3.5	3.3	3.7	The trace height will be determined to
	Trace Height (mil)
		2	3.5	3.3	3.7
						achieve a nominal 60 Ω .
		3	10.5	9.9	11.1
		Microstrip	4.30	3.75	4.85	2113 material
	Preg Er	Stripline1	4.30	3.75	4.85	2113 material
						7628 material. Trace height 3 is composed
		Stripline2	4.3	3.75	4.85	of one piece of 2113 and one piece of
						7628.
Trace Thickness (mil)		Microstrip	1.75	1.2	2.3
		Stripline	1.4	1.2	1.6
	Trace Width (mil)	Microstrip	4.0	2.5	5.5
		Stripline	4.0	2.5	5.5
Total Thickness (mil)		FR4	62.0	56.0	68.0
Trace Spacing (using		[12]/[16]
microstrip E2E/C2C)
Trace Spacing (using
	stripline E2E/C2C)	[12]/[16]
	Trace Impedance	Microstrip	60	51	69
		Stripline	60	51	69

Intel® 41210 Serial to Parallel PCI Bridge Design Guide 29