Juniper Networks SRX 210 manual Connecting the SRX210 Services Gateway to the Power Supply

SRX210 Services Gateway Hardware Guide

Figure 25: Connecting the SRX210 Services Gateway to the Power Supply

NOTE: The device must be connected to earth ground during normal operation. The protective earthing terminal on the rear of the chassis is provided to connect the device to ground.

CAUTION: We recommend using a surge protector for the power connection.

NOTE: Use the cable tie holder to secure the power cord on to the power supply point.

NOTE: We strongly recommend that you use only the 3-pin power cord supplied with your services gateway. If you are using a 2-pin power cord, then ensure that your device is adequately grounded using the grounding point available on back panel of chassis.

Related Topics ■ Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway on page 59

■Grounding the SRX210 Services Gateway on page 84

■Connecting and Organizing Interface Cables to the SRX210 Services Gateway on page 83

■SRX210 Services Gateway General Safety Guidelines and Warnings on page 133

82■ Connecting the SRX210 Services Gateway to the Power Supply