Juniper Networks SRX 210 manual Establishing Basic Connectivity, edit admin@host# commit

Chapter 16: Performing Initial Software Configuration on the SRX210 Services Gateway

19.Optionally, configure additional properties by adding the necessary configuration statements. Then commit the changes to activate them on the device.

[edit]

admin@host# commit

20.When you have finished configuring the device, exit configuration mode.

[edit] admin@host# exit admin@host>

Related Topics ■ Connecting an SRX210 Services Gateway to the CLI Locally on page 95

■Connecting an SRX210 Services Gateway to the CLI Remotely on page 96

■SRX210 Services Gateway Software Configuration Overview on page 101

■Performing Initial Software Configuration on the SRX210 Services Gateway Using the J-Web Interface on page 107

■SRX210 Services Gateway Secure Web Access Overview on page 111

Performing Initial Software Configuration on the SRX210 Services Gateway Using the J-Web Interface

This topic includes the following sections:

■Establishing Basic Connectivity on page 107

■Configuring Basic System Properties on page 108

Establishing Basic Connectivity

To establish basic connectivity:

1.Connect an Ethernet cable from any of the ge-0/0/1or fe-0/0/2to fe-0/0/7ports to the Ethernet port on the management device (workstation or laptop).

2.Connect the power cable to the device and a power source. (We recommend using a surge protector.) Note the following indications:

■Power LED (solid green): The device is receiving power.

■Status LED (solid green): The device is operating normally.

NOTE: The services gateway functions as a DHCP server and will assign an IP address to the management device.

3.Ensure that the management device acquires an IP address on the 192.168.1.0/24 subnetwork (other than 192.168.1.1) from the device.

Performing Initial Software Configuration on the SRX210 Services Gateway Using the J-Web Interface ■ 107