Juniper Networks SRX 210 manual To install the device in a rack

SRX210 Services Gateway Hardware Guide

NOTE:

■If you are installing multiple devices in one rack, install the lowest one first and proceed upward in the rack.

■Ensure that the rubber feet from the base of the chassis are removed for rack installation.

To install the device in a rack:

1.Position a mounting bracket on each side of the chassis as shown in Figure 17 on page 72.

Figure 17: Installation of SRX210 Services Gateway in a Rack — Positioning Mounting Brackets

Table 31 on page 72 lists the parts used for installing the SRX210 Services Gateway on the rack. The numbers in Figure 17 on page 72 correspond to the numbers in Table 31 on page 72.

Table 31: SRX210 Services Gateway Rack Installation Parts

S.No	Part
1	Mounting brackets
2	Screws (mounting bracket)
3	Power supply adapter tray
4	Adapter stopper bracket

2.Use a number-1 Phillips screwdriver to install the screws that secure the mounting brackets and power supply adapter tray to the chassis as shown in Figure 18 on page 73.

72■ Installing the SRX210 Services Gateway in a Rack