Juniper Networks SRX 210 manual Connecting an SRX210 Services Gateway to the CLI Locally

Chapter 15: Connecting the SRX210 Services Gateway to Management Devices

Connecting an SRX210 Services Gateway to the CLI Locally

If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect through the console port, as shown in Figure 28 on page 95.

Figure 28: Connecting to the Console Port on an SRX210 Services Gateway

NOTE: Figure 28 on page 95 shows a connection to a local management device. A remote connection to the services gateway through a modem requires the cable and connector shown (provided in the services gateway accessory box), plus a DB-9 female to DB-25 male (or similar) adapter for your modem, which you must purchase separately.

To connect to the CLI using a local management device through the console port on the services gateway:

1.Turn off power to the services gateway.

2.Turn off power to the management device, such as a PC or laptop computer, that you are using to access the CLI.

3.Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45 to DB-9 serial port adapter supplied with your services gateway (see Figure 28 on page 95).

4.Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management device (see Figure 28 on page 95).

5.Connect the other end of the Ethernet cable to the console port on the services gateway (see Figure 28 on page 95).

6.Turn on the power to the management device.

Connecting an SRX210 Services Gateway to the CLI Locally ■ 95