Juniper Networks SRX 210 manual Monitoring the SRX210 Services Gateway Components Using LEDs

SRX210 Services Gateway Hardware Guide

Monitoring the SRX210 Services Gateway Components Using LEDs

Table 43: Component LEDs on the Services Gateway

			Possible Causes and
LED	State	Meaning	Corrective Actions
Status LED	Green	Indicates that the device is	Normal condition. No
		functioning normally.	action is required.
	Amber	■ The device is starting	Normal condition. No
		up.	action is required.
		■ The Reset Config button
		is pressed.
	Red	An error is detected in the	Contact the Juniper
		device.	Networks Technical
			Assistance Center (JTAC).
			See “Juniper Networks
			Technical Assistance
			Center” on page 128.

Alarm LED	Red	The device detects a major
		alarm.

Amber	The device detects a minor
	alarm.

Off	The device is starting up.
	NOTE: When the system is
	up and running, if the Alarm
	LED is off, it indicates that
	no alarms are present on the
	device.

A major alarm indicates a critical situation on the gateway that requires immediate action.

See “Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions” on page 122.

A minor alarm requires monitoring or maintenance. If left unchecked, it might cause an interruption in service or degradation in performance.

See “Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions” on page 122.

Normal condition. No action is required.

120■ Monitoring the SRX210 Services Gateway Components Using LEDs