Juniper Networks SRX 210 manual Connecting the Modem at the SRX210 Services Gateway End

Chapter 15: Connecting the SRX210 Services Gateway to Management Devices

Related Topics ■ Connecting an SRX210 Services Gateway to the CLI Locally on page 95

■Performing Initial Software Configuration on the SRX210 Services Gateway Using the CLI on page 104

■Connecting an SRX210 Services Gateway to the J-Web Interface on page 91

■SRX210 Services Gateway Software Configuration Overview on page 101

■SRX210 Services Gateway Secure Web Access Overview on page 111

Connecting the Modem at the SRX210 Services Gateway End

NOTE: These instructions use Hayes-compatible modem commands to configure the modem. If your modem is not Hayes-compatible, refer to the documentation for your modem and enter the equivalent modem commands.

To configure the modem on the services gateway end:

1.Connect the modem to a PC or laptop computer.

2.Power on the modem.

3.From the PC or laptop computer, start your asynchronous terminal emulation application (such as Microsoft Windows HyperTerminal) and select the COM port to which the modem is connected (for example, COM1).

4.Configure the port settings shown in Table 35 on page 97.

Table 35: Port Settings to Configure the Modem on the Services Gateway End

Port Settings	Value
Bits per second	9600
Data bits	8
Parity	None
Stop bits	1
Flow control	None

5.In the HyperTerminal window, enter AT.

For more information on the AT commands, see the JUNOS Software Administration Guide.

An OK response verifies that the modem can communicate successfully with the COM port on the PC or laptop.

6.Configure the modem to answer a call on the first ring by entering ATS0=1.

Connecting the Modem at the SRX210 Services Gateway End ■ 97