Juniper Networks SRX 210 Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions

SRX210 Services Gateway Hardware Guide

Table 43: Component LEDs on the Services Gateway (continued)

			Possible Causes and
LED	State	Meaning	Corrective Actions
Voice Interface	Off	The port is inactive.	Normal condition. No
LED			action is required.
	Green (Steady)	The port is active and	Normal condition. No
		functioning normally.	action is required.
	Amber	The port is active and not	Normal condition. No
		ready for data	action is required.
		communication.
	Green (Blinking)	The port is active and data	Normal condition. No
		communication is taking	action is required.
		place.
	Red (blinking)	The port is initializing.	Normal condition. No
			action is required.

	NOTE: The Voice Interface
	port LED glows red (blinking)
	while initializing. If there is
	an error, the LED remains
	red; otherwise, the LED
	changes to green.
Red (steady)	The Port has detected a
	hardware initialization
	failure.

Contact the Juniper Networks Technical Assistance Center (JTAC). See “Juniper Networks Technical Assistance Center” on page 128.

Related Topics ■ Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 117

■Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 122

■Monitoring the SRX210 Services Gateway Power System on page 125

■Using the Reset Config Button on the SRX210 Services Gateway on page 126

■Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 127

■Juniper Networks Technical Assistance Center on page 128

Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions

When the services gateway detects an alarm condition, the alarm LED on the front panel turns red or amber as appropriate.

To view a more detailed description of the cause of the alarm , issue the show chassis alarms CLI command.

122■ Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions