Juniper Networks SRX 210 manual

Chapter 13: Connecting, Grounding, and Powering On the SRX210 Services Gateway

Connecting and Organizing Interface Cables to the SRX210 Services Gateway

You can connect the interfaces installed in the services gateway to various network media. Each type of interface on the services gateway uses a particular medium to transmit data. You must configure each network interface before it can operate on the device.

To connect and organize an interface cable to the device:

1.Have ready a length of the type of cable used by the interface.

2.Insert the cable connector into the cable connector port on the interface faceplate.

3.Arrange network cables as follows to prevent them from dislodging or developing stress points:

■Secure cables so that they are not supporting their own weight as they hang to the floor.

■Place excess cable out of the way in neatly coiled loops.

■Use fasteners to maintain the shape of cable loops.

Related Topics ■

■

■

Connecting the SRX210 Services Gateway to the Power Supply on page 81

Grounding the SRX210 Services Gateway on page 84

Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 161

■SRX210 Services Gateway Installation Safety Guidelines and Warnings on page 138

Connecting and Organizing Interface Cables to the SRX210 Services Gateway ■ 83