Test Tone

For specifying whether to output the audio test signals (1 kHz) during color bar output. [Setting Values: On, ROff]

Mic Wind Cut

For selecting whether to cut the low frequencies of the audio input signals (low-cut) when the [INPUT1/

INPUT2] switch is set to “MIC” or “MIC+48V”.Set this item to reduce wind noise from the microphone.0 Both:Enables low-cut on both the [INPUT1] and [INPUT2] terminals.0 INPUT2:Enables low-cut on the audio of the [INPUT2]terminal only.0 INPUT1:Enables low-cut on the audio of the [INPUT1]

terminal only.

0 Off:

Disables low-cut.[Setting Values: Both, INPUT2, INPUT1, ROff]Int. Mic Wind Cut

For selecting whether to cut the low frequencies of the audio input signals (low-cut) from the built-in microphone. Set this item to “On” to reduce wind

noise from the microphone. [Setting Values: On, ROff]Equalizer

You can correct the characteristic and enhance the sound of the connected microphone using this equalizer setting.

For setting the audio frequency from a 5-band equalizer.0 Frequency:100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz0 Variable level:± 6dB (1dB step)

Memo :

0Audio will be recorded in the characteristic set in the equalizer.0Set all bands to “0dB” to bypass the equalizer.

0When the equalizer level is set to +side, the audio may be distorted. In this case, reduce the recording level in Manual mode.

0If the values of multiple frequencies are changed, the specified levels and the actual levels may be different due to interference between the frequency bands.

0This function is enabled only when both [Mic Wind Cut] and [Int. Mic Wind Cut] are set to “Off”.

Monitor

For setting the audio sound of the [x] terminal to stereo or mixed sound when the [MONITOR]

switch on the LCD monitor is set to “BOTH”.0 Mix:Outputs mixed sound (mixed sound of CH1 and CH2) to both L and R.0 Stereo:Outputs stereo sound (outputs audio sound of CH1 to L, and CH2 to R).[Setting Values: RMix, Stereo]

Memo :

0If both CH1 and CH2 are built-in microphones, stereo sound is output from the [x] terminal regardless of the [Monitor] setting.

Alarm Level

For selecting whether to turn on the warning tone as well as setting the volume.

The warning tone is output from the monitor speaker or [x] terminal.[Setting Values: RHigh, Middle, Low, Off]Audio On FULL AUTOFor setting whether to enable Auto for audio when [FULL AUTO] is set to “ON”.0 SW Set:

Sets the audio recording mode following the [CH1/CH2 AUTO/MANUAL] selection switch

setting.

0 Auto:

Sets audio recording mode to the forced auto mode.[Setting Values: SW Set, RAuto]

Settings Detailed and Display Menu

103