Getting Started
Name and Function of Parts
⬛Ceiling Mount (Terminal Side)
9
| 8 |
1 | 7 |
| 6 |
2 | 5 |
3 | 4 |
|
1Safety Wire
Hang this wire to the wire fastening hook & to prevent the camera from falling down.
2[VIDEO OUT] Coaxial Cable Terminal Output terminal for composite video signals (1
Output is restricted signals in the NTSC for- mat only.
3[POWER INPUT DC12V] DC12V Input Ter- minal
Connect this to the Converter Unit that has been supplied.
4Safety Wire Mounting Hole
To prevent the camera from falling down, at- tach a wire from the ceiling slab or channel to this hole.
5[10BASE-T/100BASE-TX] 10BASE-T/ 100BASE-TX Terminal
This is a
is used for connecting to the network via LAN cables. (☞ Page 17)
6Locking Screw
Ensure to fasten the camera by fastening this screw to the camera clamping bracket #.
7[ALARM IN/OUT] Alarm Input/Output Ter- minals
Terminals for alarm input and output. (☞ Page 16)
Pin No. | Signal Name | ||
1 | Alarm Output |
| Alarm Output 1 |
|
|
| |
2 |
| Alarm Output 2 | |
|
| ||
3 | Alarm Input |
| Alarm Input 1 |
4 |
| Alarm Input 2 | |
|
| ||
5 |
| GND | |
8Cover
This is a protection cover. Cut a slit in the rub-
ber cap attached to the cover when wiring cables. (☞ Page 14)
9Cover Fastening Screw
This is used for fastening the cover 8and ceil- ing mount. To remove cover 8, do so by un- fastening this screw.
10
