JVC VN-C625 manual Alarm Setting

Settings (Step 3 Setting Using the V.Networks Controller)

3-8 Alarm Setting (Continued)

1Message

Message entered in the textbox will be displayed when there is an alarm input.

(Up to 100 single-byte characters)

3Playing wave file

Plays back a designated Wave file when there is an alarm input. Click the [Browse] button to specify a file.

2Recording

Starts recording when there is an alarm input. Non-stop : Recording continues until the Stop

button is pressed.

1 minute : Recording stops after 1 minute.

Note

Alarm actions may be delayed due to PC performance if a large Wave file (.wav) is selected.

Notes 4 Execute application file

●The [1 minute] mode is used for conserving hard disk space.

●In this mode, recording stops after 1 minute even if recording has already started before the alarm input.

Executes a designated program when there is an alarm input. Click the [Browse] button to specify a program.

Notes

Alarm Operation

The following settings are required for the operation of the set alarm.

1.[Alarm Reg] is checked. This item is located under the [Setting] menu of the "V. Networks Controller". (☞ Page 60)

2.All alarm settings in the [Alarm Setting] of the "VN-C625U Setup Tool" are enabled. (☞ Page 36)

Relay Alarm

When the Relay Alarm function is enabled, subsequent alarms will not be activated.

70