•The LED Indicator on the EFFECT and CHORUS buttons will be on only when the active Priority Part has these effects turned on.
Example
Assume that your CP is set up according to the following chart:
| SOLO | RIGHT1 | RIGHT 2 | LEFT | INDICATOR |
Part | Inactive | Active | Inactive | Active |
|
Effect | On | On | Off | On | On |
If you then select a different sound for RIGHT1, the Effect setting for the SOLO, RIGHT2, LEFT will be turned off automatically. This is because RIGHT1 is the Priority Part (note that the SOLO Part is NOT the Priority Part because it was inactive).
The chart would now look like this:
| SOLO | RIGHT1 | RIGHT 2 | LEFT | INDICATOR |
Part | Inactive | Active | Inactive | Active |
|
Effect | Off | On | Off | Off | On |
Even if you now assign a new sound to the SOLO Part, the Effect settings for the other Parts won’t change, because SOLO is still inactive, so therefore would not have priority.
Once you make the SOLO Part active, however, it would now be considered the Priority Part. The Effect settings for the other Parts will again be turned off. The Indicator light on the EFFECT button will now reflect the Effect status for the sound assigned to SOLO.
| SOLO | RIGHT1 | RIGHT 2 | LEFT | INDICATOR |
Part | Active | Active | Inactive | Active |
|
Effect | Off | Off | Off | Off | Off |
At this point, if the Effect that has been called up along with the SOLO sound is one that you’d like to use for the other Parts, simply select Effect On in the LCD display for those Parts.
Basic Controls | P. 21 |
