Kyocera 2550, 2050, 1650 manual Administrator Management Code Change, Auto Sleep, 1600, # keys

System Menu

5Press the Enter key.

6Press the Reset key. The message display returns to the copier basic screen.

Important!

1

2

3

4

5

6

Administrator Management Code Change

You can change the four-digit management code for the administrator of this machine.

•If you change the management code, be sure to note it. If you should forget the management code, contact your service representative.

•The management code at the factory default setting is 1600 for the 16 ppm model, 2000 for the 20 ppm model, and 2500 for the 25 ppm model.

Display the Machine default screen. (See How to Display the Machine Default Screen on page 3-12.)

Press the S key or the T key to select PIN #
	Machine default:
Change [MGMT Code entry].
		Date/Time		: 08:48
		Display Contrast		:
		PIN # Change
Press the Enter key.
Use the numeric keys to input the new administrator
	Management code change:
management code.
			1600
	# keys
Press the Enter key.

Press the Reset key. The message display returns to the copier basic screen.

	Auto Sleep
	The machine enters automatically the sleep mode when the preset time elapses without any
	operation if this setting is turned On.
Notes	• This setting is displayed only on the inch specification machine.

•You can disable the auto sleep function if this function causes inconvenience. It is recommended, however, to set a longer time that elapses before the auto sleep function is activated, before disabling this function.

1Display the Machine default screen. (See How to Display the Machine Default Screen on page 3-12.)

2Press the S key or the T key to select Auto Sleep. Machine default:

Display Contrast	:
PIN # Change	: On
Auto Sleep

3Press the Enter key.

4Press the S key or the T key to select On or Off.

Auto Sleep:

Off

*On

3-23