Kyocera 2050, 1650, 2550 manual Selection of Special Paper, Appendix-5

Appendix

Special Paper

This section describes printing onto special paper other than standard paper.

You can use the following types of special paper in this machine.

•Transparency

•Preprinted paper

•Label

•Bond paper

•Recycled paper

•Thin paper (45 to 64 g/m²)

•Letterhead

•Color paper

•Prepunched paper

•Envelope

•Postcard

•Thick paper (90 to 160 g/m²)

•High-quality paper

For these types of paper, use paper specified for copiers or page printers. When using transparencies, labels, thin paper, envelopes, postcards, or thick paper, feed the paper from the multi-bypass tray.

Selection of Special Paper

Special paper that satisfies the conditions shown on and after the next page can be used in this machine. However, since special paper differs significantly in paper composition and quality, special paper is more likely to cause problems than standard paper during printing. When using special paper, perform trial printing using this machine and check to see if the results are satisfactory before purchasing it. Notes in printing for principal types of special paper are described on and after the next page. Kyocera Mita shall not be liable for any danger to a person or machine that is caused by using special paper (e.g., special paper affected by moisture).

Transparency

Transparencies must withstand the heat of fusing during the printing process. The recommended transparency product is shown below.

3M CG3700 (Letter, A4)

The specifications of transparencies that can be used in this machine are shown in the table below.

Item	Specifications
Heat resistance	Must withstand heat at least 190 °C.
Thickness	0.100 to 0.110 mm
Material	Polyester
Size tolerance	±0.7 mm
Squareness of corners	90° ±0.2°

To avoid problems, feed transparencies from the multi-bypass tray. Be sure to set them with the long side toward the main body.

If transparencies cause paper jams frequently, pull the end of the transparencies carefully each time one sheet is output.

Appendix-5