Kyocera 9530DN manual Paper Handling, Binding Mode

Using the Operation Panel

Activating the duplexer is done by selecting either short edge or long edge binding mode.

NOTE: Duplex printing can be also performed from the MP tray. When the MP tray is set to First Mode (First), the paper size and paper type will be the same as those of the paper cassette currently set at the paper feed source. If the paper to be fed from the MP tray does not match the paper size and paper type of the current paper feed source cassette, a paper jam may occur.

Binding Mode

The term binding refers to the manner in which printed pages of paper are joined together (by gluing, stitching, etc.) in book form. The two possible types of binding are long-edge binding, in which pages are joined together along their long edge; and short-edge binding, in which they are joined together along their short edge. In selecting a binding type, you must also consider the orientation of the printed page. You can use long-edge or short-edge binding with either landscape or portrait printing.

Depending on the binding type and print orientation, the duplex unit provides four types of binding setups. These are: (1) portrait, long-edge,

(2)portrait, short edge, (3) landscape, long-edge, and (4) landscape, short- edge. The figure below shows these binding setups.

(1)

Portrait, long-edge

(3)

Landscape, long-edge

(2)	Portrait,
	short-edge
	Landscape,
	short-edge

(4)

1

2

Binding Setups

To select duplex printing and binding setup from the operation panel, proceed as follows.

Press [MENU].

Press U or V repeatedly until Paper	Paper Handling >
Handling > appears.

3 Press Z.

2-80 ADVANCED OPERATION GUIDE