Using the Operation Panel
Staple Error Detection Setting
This setting controls whether or not message Add staples appears when the finisher units runs out of staples during output of a stabled job.
On
Off
Message is displayed and printing pauses. Printing resumes automatically when staples are replenished.
Message is displayed, but printing continues without stapling.
1
2
3
4
5
6
7
8
9
10
Press [MENU].
Press U or V repeatedly until Others > appears.
Press Z.
Press U or V repeatedly until > Finishing Error > appears.
Press Z.
Press U or V repeatedly until >>Staple appears.
Press [OK]. A blinking question mark (?) appears.
Press U or V to change Off to On.
Press [OK].
To exit the menu selection, press [MENU].
Others >
>Finishing > Error
>>Staple Off
>>Staple
? Off
ADVANCED OPERATION GUIDE |