Kyocera 9530DN Changing the Interface Parameters, Changing Parallel Interface Modes, ?Parallel

Using the Operation Panel

Changing the Interface Parameters

The printer is equipped with both a parallel and serial interface or a network interface. Further, an optional RS-232C interface card or network interface card may be installed if desired. Various printing environment parameters such as the default emulation can be changed independently on different interfaces by using the printer’s menu selection system. Select the interface to apply the changes in the procedure described below.

NOTE: This interface selection described below does not select which interface data will be received from. The printer automatically selects an interface.

Changing Parallel Interface Modes

1

2

3

4

5

6

The parallel interface supports a bi–directional/high–speed mode according to IEEE standards. Normally, this interface is used under the default setting Auto. For details, refer to Chapter 5 Computer Interface. After setting the interface, be sure to reset the printer or turn the power off at least once. The new setting will be enabled thereafter.

Press [MENU].

Press U or V repeatedly until Interface > appears. One of the interface names shown below appears, indicating the current interface.

Parallel (default)

USB

Network

Option (only when an optional network interface card is installed) Serial (only when an optional RS-232C interface card is installed)

Press [OK]. A blinking question mark (?)	Interface	>
appears.

?Parallel

If Parallel is not displayed, press U or V repeatedly until Parallel appears.

Press [OK] again.

Press Z. The message display changes to the communication mode menu.

Press [OK]. A blinking question mark (?)	>Parallel I/F
appears.

?Auto

ADVANCED OPERATION GUIDE 2-35