Using the Operation Panel
For example, if the total memory installed in your printer
To activate RAM disk in the printer’s memory, first you must use the printer’s menu selection system. The printer’s menu selection system allows you to perform the following operations on the RAM disk.
•Setting RAM Disk Size
•Reading Data
•Writing Data
•Deleting Data
•Printing of List of Partitions
By default, the RAM disk is not activated (Off). To confirm the RAM disk size or activate the RAM disk, proceed as follows:
Setting RAM Disk Size
1 | Press [MENU]. |
2 | Press U or V repeatedly until >RAM Disk |
| |
| Mode appears. |
3 | Press [OK]. A blinking question mark (?) |
| appears. |
4 | Press U or V to select On. |
| |
5 | Press [OK]. A blinking question mark (?) |
| disappears and > appears on the right side. |
6 | Press Z. |
| |
7 | Press U or V repeatedly until >RAM Disk |
| |
| Size appears. The data size also appears. |
8 | Press [OK]. A blinking cursor (_) appears. |
9 | Press U or V to display the desired size. |
|
>RAM Disk Mode Off
>RAM Disk Mode
? Off
>RAM Disk Mode
?On
>RAM Disk Mode > On
>RAM Disk Size 0028 MByte
>RAM Disk Size 0028 MByte
ADVANCED OPERATION GUIDE |