Using the Operation Panel
Message Display
The message display gives information in the form of short messages. The nine messages listed below are displayed during normal
Other messages that may appear when the printer needs the operator’s attention are explained on page
Message | Meaning |
|
|
Self test | The printer is |
|
|
Original toner | The installed toner container is displayed if |
installed | determined to be original toner container by |
| the |
| switched on. |
| When using an original Kyocera toner |
| container, toner remaining warnings and toner |
| replacement messages are at times displayed |
| in the operation panel. |
|
|
Please wait | The printer is warming up and is not ready. |
| When the printer is switched on for the first |
| time after the toner container is installed, |
| (Adding toner) also appears. |
Ready | The printer is ready to print. |
|
|
Processing | The printer is receiving data, generating |
| graphics, reading a memory card/hard disk, or |
| printing. |
|
|
Sleeping | The printer is in Sleep mode. The printer |
| wakes from Sleep mode whenever a key on |
| the operation panel is pressed, the cover is |
| opened or closed, or data is received. The |
| printer then warms up and goes online. The |
| time that the printer takes to enter Sleep mode |
| depends on the Sleep Timer setting. |
|
|
Canceling data | Jobs inside the printer are being canceled. To |
| cancel a job, refer to the table on page |
|
|
Waiting | The printer is waiting for the |
| command before printing the last page. |
| Pressing [GO] allows you to obtain the last |
| page immediately. |
FormFeed | The printer is printing the last page after a |
TimeOut | waiting period. |
ADVANCED OPERATION GUIDE |