Kyocera 9530DN Read Fonts Processing, Memory Card Read Data DataS001 ?DataS001, Reading Data

Using the Operation Panel

6	Press [OK]. Processing appears and the
	reading of data from the memory card
	starts.
7	Press [MENU] to return to Ready.

Reading Data

>Read Fonts

Processing

Data stored on a memory card can be read. To read data on a memory card, proceed as follows.

1

2

3

4

5

Press [MENU].

Press U or V repeatedly until Memory Card > appears.

Press Z.

Press Uor Vrepeatedly until >Read Data appears. The data name also appears.

Press [OK]. A blinking question mark (?) appears before the data name.

Memory Card >

>Read Data

DataS001

>Read Data

?DataS001

6

7

Press U or V to display the desired data name.

Press [OK]. Processing appears and the reading of data from the memory card starts.

Writing Data

Data can be written to a memory card until no space is left for storing. When writing to a memory card, a name is assigned to the file automatically. You can use the procedure explained later in this section to print a list of data names for confirmation.

To write data to a memory card, proceed as follows.

First check that the memory card is properly formatted. Otherwise, the >Write Data message to be explained below will not be shown on the message display.

If the memory card inserted in the memory card slot is not formatted, the >Format will automatically appear on the display. Refer to Formatting on page 2-66.

ADVANCED OPERATION GUIDE 2-63