Using the Operation Panel
1
2
To confirm or change network card parameters, proceed as follows:
Press [MENU].
Press U or V repeatedly until Interface > appears. One of the interface names shown below appears, indicating the current interface.
Parallel |
|
USB | (default) |
Network | |
Option | (only when an optional network interface card is installed) |
Serial | (only when an optional |
3
4
Press [OK]. A blinking question mark (?) appears.
Press U or V repeatedly until Network appears.
Interface
?Parallel
Interface
?Network
5
6
Press [OK] again.
Press Z. Each time U or V is pressed, the display changes as shown below.
If On, print the standard Network Interface Status Page after the Printer Status Page. Refer to page
If On, print the optional Network Interface Status Page after the Printer Status Page. Refer to page
>NetWare Off
>TCP/IP Off
>AppleTalk Off
>Network Status Page Off
>Opt. StatusPage On
| ADVANCED OPERATION GUIDE |