Kyocera FS-C8026N manual Changing Network Interface Parameters, Interface ? Serial, Baud Rate ?

4	Press the U or V key repeatedly until Serial
	appears.
			Interface
		? Serial
5
	Press the ENTER key again.
6	Press the Z key. One of the following serial
	parameters is indicated (Baud rate for example).

Pressing the U or V key toggles through the serial parameters as follows. To change the serial parameter, press the ENTER key. Use the U or V key to change the value or selection.

3.5 Changing the Interface Parameters

Press the U or V key to scroll through values. When 115200 is displayed, press the ENTER key. Press the MODE key to exit the menu selection.

	Some computers may not be able to handle a
	baud rate of 115200 bps. If you set the baud
Note	rate to 115200 and encounter communication
	problems, select a lower baud rate.

3.5.3Changing Network Interface Parameters

The printer has a built-in network interface which supports TCP/IP, NetWare and EtherTalk protocols. In addition, you can install an optional network interface card in the printer’s extension slot (OPT).

>Baud Rate 9600

>Data Bits 8

>Stop Bits 1

>Parity None

>Protocol

DTR(pos.)&XON

Range

1200, 2400, 4800,

9600 (Default),

19200, 38400,

57600, 115200

7 or 8 (Default)

1 (Default) or 2

None (Default), Odd, Even, or Ignore

DTR (pos.) &

Xon (Default), DTR

(positive), DTR (nega-

tive), XON/XOFF,

ETX/ACK

To adjust the printer for networking parameters of the current network, using the operator panel, you can:

•Activate or deactivate TCP/IP, NetWare, and AppleTalk

•Activate or deactivate DHCP

•Enter IP address, subnet mask address, and default gateway address

•Determine whether to print a network status pages automatically when the printer is turned on

To confirm or change networking parameters, proceed as follows:

1	Press the MENU key.
2	Press the U or V key repeatedly until Interface
	> appears.
3	If the current interface is other than network, press the
	ENTER key. A blinking question mark (?) appears.
			Interface	>
		? Parallel

If the optional network interface card is installed in the printer, Option will be displayed. The setting

For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press the ENTER key. A blinking question mark (?) appears.

>Baud Rate ? 9600

procedure is basically the same even in this case.

4	Press the U or V key repeatedly until Network
	appears.
			Interface	>
		? Network
5
	Press the ENTER key again.

3-29