5: Configuration Using Web Manager

 

 

 

 

Connect Response

A single character is transmitted to the serial port when there is a change

 

 

in connection state. The default setting is None.

 

Use Hostlist

If this option is set to Yes, the device server scrolls through the host list

 

 

until it connects to a device listed in the host list table. Once it connects,

 

 

the unit stops trying to connect to any others. If this connection fails, the

 

 

unit continues to scroll through the table until it connects to another IP in

 

 

the host list.

 

 

The host list is disabled for Manual Mode and for Modem Mode. The unit

 

 

will not accept a data connection from a remote device when the host list

 

 

option is enabled.

 

LED

Select Blink for the status LEDs to blink upon connection or None for no

 

 

LED output. The default setting is Blink.

 

 

 

Disconnect Mode

 

 

 

 

 

On Mdm_Ctrl_In Drop

Set to Yes for the network connection to or from the serial port to

 

 

disconnect (drop) when Modem Control In transitions from an asserted

 

 

state to not asserted state. The default setting is No.

 

Hard Disconnect

When set to Yes, the TCP connection closes even if the remote site does

 

 

not acknowledge the disconnect request.

 

Check EOT (Ctrl-D)

Select Yes to drop the connection when Ctrl-Dor Hex 04 is detected.

 

 

Both Telnet Com Port Cntrl and Check EOT

 

 

(Ctrl+ D) must be enabled for Disconnect with EOT to function properly.

 

 

Ctrl+D is only detected going from the serial port to the network. The

 

 

default setting is No.

 

Inactivity Timeout

Use this parameter to set an inactivity timeout. The unit drops the

 

 

connection if there is no activity on the serial line before the set time

 

 

expires. Enter time in the format mm:ss, where m is the number of

 

 

minutes and s is the number of seconds. To disable the inactivity timeout,

 

 

enter 00:00.

 

 

 

3.When you are finished, click the OK button.

4.On the main menu, click Apply Settings.

Connection Settings - UDP

To configure a channel’s UDP settings:

1.On the main menu, click Connection. The Connection Settings window for the selected channel displays.

2.In the available fields, enter or modify the following information:

xDirect User Guide

33

Page 33
Image 33
Lantronix 900-653-R manual Connection Settings UDP, To configure a channel’s UDP settings