8: Setup Mode: Channel Configuration
xDirect User Guide 48
SendChar 1 (00)
SendChar 2 (00)
To enable the hostlist:
1. Enter a Connect Mode of 0x20 (2X), where X is any digit. The menu shows you a list of current
entries already defined in the product.
2. To delete, modify, or add an entry, select Yes. If you enter an IP address of 0.0.0.0, that entry
and all others after it are deleted.
3. After completing the hostlist, repeat the previous step if necessary to edit the hostlist again.
4. For Retrycounter, enter the number of times the Lantronix unit should try to make a good
network connection to a hostlist entry that it has successfully ARPed. The range is 1-15, with
the default set to 3.
5. For Retrytimeout, enter the number of seconds the unit should wait before failing an
attempted connection. The time is stored as units of milliseconds in the range of 10-65535.
The default setting is 250.
d) Datagram Typee) Modem Mode
In Modem (Emulation) Mode, the unit presents a modem interface to the attached serial device. It
accepts AT-style modem commands and handles the modem signals correctly.
Normally, there is a modem connected to a local PC and a modem connected to a remote
machine. A user must dial from the local PC to the remote machine, accumulating phone charges
for each connection. Modem Mode allows you to replace modems with xDirects, and to use an
Ethernet connection instead of a phone call. By not having to change communications
applications, you avoid potentially expensive phone calls.
To select Modem Mode, set the Connect Mode to C6 (no echo), D6 (echo with full verbose), D7
(echo with numeric response), CF (modem responses only, numeric response), or CE (modem
responses only, full verbose).
Note: If the unit is in Modem Mode, and the serial port is idle, the unit can still accept
network TCP connections to the serial port if Connect Mode is set to C6 (no echo), D6
(echo with full verbose), D7 (echo with numeric response, CF (modem responses only,
numeric response), or CE (modem responses only, full verbose).
Directed UDP When selecting this option, the prompt requests the Datagram type. Enter 01 for
directed or broadcast UDP. Datagrams of type 01 can be sent as a broadcast by
enabling this option. The default is not to broadcast.
Note: Datagrams are sent as subnet-directed broadcasts.
When the UDP option is in effect, the unit never attempts to initiate a TCP
connection because it uses UDP datagrams to send and receive data.
Without Echo In Modem Mode, echo refers to the echo of all of the characters
entered in command mode; it does not mean to echo data that is
transferred. Quiet Mode (without echo) refers to the modem not
sending an answer to the commands received (or displaying what
was typed).